Denial Cost ReportPage 1 of 2
Reclaimrwww.reclaimr.ai

Prepared for your shop

Denial Cost Report

Your shop may be losing $696,519 a year

Lost revenue

$672,000

Cut from your estimates and never paid, for work your shop already did.

Wasted time

$24,519

600 hours of estimator time spent fighting short pays.

Your numbers

The numbers in a box are the ones you entered. Everything else is worked out from them.

Lost revenue

Short pays a month25
Average carrier's cut per file×$2,240
Months×12
Lost revenue a year=$672,000

Wasted time

Short pays a month25
Hours to fight each one×2
Months×12
Hours a year=600
Estimator pay an hourYour $85,000 a year ÷ 2,080 hours×$40.87
Wasted time a year=$24,519

Want this for your shop?

Reclaimr checks your estimates line by line, identifies what insurance cut, and writes a justification to get you paid.

Book a 30-minute walkthroughwww.reclaimr.ai/book · (443) 952-4052
Reclaimrwww.reclaimr.ai

Next steps

How to get more of your estimate paid

Eight steps you can use on your next estimate and your next supplement. Start with step 1: a carrier can't pay a line that was never written.

  1. Write every operation as its own line

    Before the estimate goes out, give each scan, calibration, refinish step, one-time-use part and corrosion protection a line of its own. Work folded into another line is the easiest to cut.

  2. Always answer a cut scan or calibration

    Write the pre-repair scan, the post-repair scan and each calibration separately, and quote the automaker's requirement for that vehicle on the line.

    More: The Denial Files, Scans & Calibrations

  3. List each refinish step

    Blend, three-stage, tint and spray-out, and feather, prime and block each get a line, citing your estimating system's guide where it says the step isn't included.

    More: The Denial Files, Paint

  4. Name each one-time-use part

    List every clip, rivet and bolt the automaker says not to reuse, one by one, and corrosion protection on every repaired or welded panel.

  5. Dispute aftermarket swaps when you wrote the automaker's part

    Send the automaker's position statement for that part, most of all on parts near a sensor or camera.

    More: The Denial Files, Parts

  6. Cite what this carrier paid you before, in its own words

    If it paid the operation on one of your earlier repair orders, put that RO number in the letter, “You previously paid for this on RO #31649.” Write the line the way the paid one was written.

  7. Ask again after every supplement

    The same carrier pays a line on one file and cuts it on another. Each time a new carrier estimate comes in, compare it again and resend what's still missing. A second or third ask is normal.

  8. Settle your labor rate before the first estimate

    Post your door rate, keep a dated rate sheet, and send it with your first contact on every claim. Short on time? Work your biggest files first, and back small fees like disposal with the invoice.

The Denial Files

What carriers cut from collision estimates and what gets it paid, one topic at a time: reclaimr.ai/the-denial-files

Rather not do it by hand?

Reclaimr checks each estimate line by line before it goes out, and writes the cited answer when a carrier cuts anyway. Book a 30-minute walkthrough